Honda 2004 Odyssey, Service Manual

Page: 1377 / 2459

＊０１
０２
20-12
Doors
Front Door Glass and Regulator Replacement (cont’d)
Fastener Locations
D : Bolt, 4 E : Bolt, 3
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
D
C
E
E
D
D
E
F
A
D
’03-04 models driver’s
C
E
E
D
D
E
D
D
A
F
B
A
3. Disconnect and detach the connectors (A), and
for ’03-04 models driver’s door, detach the
connectors from the door harness bracket (B).
Detach the harness clip (C) from the door. Remove
the bolts (D) and loosen the bolts (E), then remove
the regulator (F) through the hole in the door.
4. Apply multipurpose grease to all the sliding
surfaces of the regulator (A) where shown.
5. Install the glass and regulator in the reverse order
of removal, and note these items:
• Roll the glass up and down to see if it moves
freely without binding.
• Make sure that there is no clearance between the
glass and glass run channel when the glass is
closed.
• Adjust the position of the glass as necessary (see
page 20-23).
• Check for water leaks (see step 7 on page 20-23).
• For ’03-04 models: Reset the power window
control unit (see page 22-200).
• Test-drive and check for wind noise and rattles.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perimeter.
03/07/29 10:00:03 61S0X050_200_0014