Honda 2004 Odyssey, Service Manual

Page: 1670 / 2459

＊０１
Ｓ０Ｘ４Ａ１２Ｇ４４２０００４０３０２ＦＥＡＴ００
０１
Ｓ０Ｘ４Ａ１２Ｇ４４２０００４０３０２ＫＢＡＴ００
21-139 21-139
Rear Mode Control Motor Test Rear Mode Control Motor
Replacement
REAR MODE CONTROL MOTOR
B
A
1. Disconnect the 7P connector from the rear mode
control motor.
Incorrectly applying power and ground to
the rear mode control motor will damage it.
Follow the instructions carefully.
2. Connect battery power to the No. 2 terminal of the
rear mode control motor, and ground the No. 1
terminal. To avoid damaging the rear mode control
motor, do not reverse power and ground.
3. Using a jumper wire, connect the No. 1 terminal
individually to the No. 3, 4 and 6 terminals in that
order. Each time the connection is made, the rear
mode control motor should run smoothly and stop.
If the rear mode control motor does not run when
jumping the first terminal, jump that terminal again
after jumping the other terminals. The rear mode
control motor is OK if it runs when jumping the first
terminal again.
4. If the rear mode control motor does not run in step
3, remove it, then check the rear mode control
linkage and doors for smooth movement.
• If the linkage and doors move smoothly, replace
the rear mode control motor.
• If the linkage or doors stick or bind, repair them
as needed.
1. Remove the rear blower unit (see page 21-142).
2. Disconnect the 7P connector (A) from the rear
mode control motor (B). Remove the self-tapping
screws and the rear mode control motor.
3. Install the motor in the reverse order of removal.
Make sure the pin on the motor is properly
engaged with the linkage. After installation, make
sure the motor runs smoothly.
03/07/29 10:14:20 61S0X050_210_0140