Honda 2004 Odyssey, Service Manual

Page: 1379 / 2459

０３ ０１
０２
Ｓ０Ｘ４Ａ００Ｊ１６１７０９２１３０１ＫＢＡＴ００
20-14 20-14
Doors
Sliding Door Panel Removal/
Installation (cont’d) Sliding Door Outer Handle
Replacement
Fastener Locations
: Screw, 1 : Clip, 12
A
B
Fastener Locations
: Screw, 2
A
Fastener Locations
: Bolt
Power sliding door, 4
Manual sliding door, 3
6 x 1.0 mm
8 N·m (0.8 kgf·m,
6 lbf·ft)
B
A
C
D
4. Pry out the cap (A), and remove the screw. Release
the clips that hold the door panel (B) with the trim
pad remover used in step 1, then remove the door
panel. Remove the door panel with as little bending
as possible to avoid creasing or breaking it.
5. Install the door panel in the reverse order of
removal, and note these items:
• Replace any damaged clips.
• Push the clips into place securely.
6. For EX and EX-L models: Re-home the power
sliding doors (see page 22-291).
NOTE: Put on gloves to protect your hands.
1. Remove the door panel (see page 20-13).
2. Remove the screws, then remove the lock knob (A).
3. Pull the plastic cover back as necessary (see page
20-4).
4. Remove the lower bolt(s) and loosen the upper
bolts, release the door latch cable (A) and door auto
close cable or lower roller lock cable (B) from the
cable holder (C), then move the door lock remote
control (D) by sliding it up and rearward. Do not
remove the door lock remote control at this time.
Take care not to bend any of the cables.
03/07/29 10:00:04 61S0X050_200_0016