Honda 2004 Odyssey, Service Manual

Page: 2055 / 2459

＊０１
＊０２
０１
Ｓ０Ｘ４Ａ８２Ｊ３６１００００００００ＦＥＡＴ００
＋
− ＋
＋
Start-up procedure System Links
Tire Calibrate
22-376
Navigation System
System Diagnosis Test
Diagnosis Menu
System Links Tire-Calibrate
In-Line Diag
Monitor Check
Unit Check
Yaw Rate
Cyclic Diag
Rear Camera
Return
DIAGNOSIS MENU SCREEN
’03-04 Models Only
System Links
ANT
Disp
A/C
Navi ECU
OK Rerutn
GPS
Tire-Calibrate
Tire-Cal Factor
Auto-Tuning
STD
7.0%
Set
ON
Tire-Cal Tuning 7.0%
Return
1. Turn the ignition switch ON (II), select ‘‘OK’’ on the
Disclaimer screen then press and hold the buttons
in this order: (1) MENU button. (2) MAP/GUIDE
button, (3) CANCEL button, and keep them pressed
2. After the display changes to the diagnosis menu
screen, select the item you want to check, and the
check will start. To return to the previous screen,
select the ‘‘RETURN’’ on the screen.
• System Links.
• Tire Calibrate.
• Monitor Check.
• Yaw Rate.
• Unit Check.
• Cyclic Diag.
• Rear camera. (’03-04 Models Only)
• In-line Diag.
• During diagnosis, all of the communication lines
connecting the components are shown in yellow.
• If the system is OK, all of the communication lines
connecting the components will change to green, the
screen will indicate ‘‘OK’’, and a tone will sound.
• If there is a problem in the system, the faulty
communication line will change to red, the screen
will indicate ‘‘NG’’, and a tone will sound.
NOTE: If the A/C link is red, refer to climate control
manual switch troubleshooting (see page 21-116).
• The indication on the screen will not change until the
ignition switch is cycled. After repairing the system,
turn the ignition switch OFF to reset the system, then
return to the Diagnosis Menu screen, and run system
Links again.
• The ‘‘AUTO TUNING’’ is factory-set to ‘‘ON’’, and it
should remain on. If you find it has been turned OFF,
turn it back ON.
• The ‘‘TIRE-CAL TUNING’’ should not be used. The
AUTO TUNING function keeps the system in better
tune.
03/07/29 10:28:47 61S0X050_220_0378
for 5 seconds.