Honda 2004 Odyssey, Service Manual

Page: 182 / 2459

− −
− −
＊０１
＊０２
＊０３
＊０４
Ｓ０Ｘ４Ａ００Ａ１４６８０２０００００ＭＢＡＴ００
Intake: 0.20 0.24 mm (0.008 0.009 in.)
Exhaust: 0.28 0.32 mm (0.011 0.013 in.)
Adjusting screw locations:
6-15
Valve Clearance Adjustment
B
A
B
A
B
INTAKE
REAR:
EXHAUST
No. 1 No. 2 No. 3
No. 1 No. 2 No. 3
FRONT:
EXHAUST
No. 4 No. 5 No. 6
No. 4 No. 5 No. 6
A
7 x 0.75 mm
20 N·m (2.0 kgf·m, 14 lbf·ft)
1. Remove the cylinder head covers (see page 6-34).
2. Set the No. 1 piston at top dead center (TDC). Align
the pointer (A) on the front upper cover with the
No. 1 piston TDC mark (B) on the front camshaft
pulley.
3. Select the correct thickness feeler gauge for the
valves you’re going to check.
4. Insert the feeler gauge (A) between the adjusting
screw (B) and the end of the valve stem and slide it
back and forth; you should feel a slight amount of
drag.
5. If you feel too much or too little drag, loosen the
locknut (A), and turn the adjusting screw (B) until
the drag on the feeler gauge is correct.
6. Tighten the locknut and recheck the clearance.
Repeat the adjustment, if necessary.
(cont’d)
03/07/29 09:10:40 61S0X050_060_0015