Honda 2004 Odyssey, Service Manual

Page: 606 / 2459

−
−
− − −
０１
０２
Ｓ０Ｘ４Ａ００Ａ２０３２３４２５２３１ＦＥＡＴ００
Special Tools Required
11-297
EVAP Two Way Valve Test
A973X-041-
XXXXX
A
B
07JAZ-001000B
A973X-041-
XXXXX
A
07JAZ-001000B
• Vacuum pump/gauge, 0 30 in.Hg A973X-041-XXXXX
• Vacuum/pressure gauge, 0 4 in.Hg 07JAZ-001000B
1. Remove the fuel fill cap.
2. Disconnect the vapor line from the EVAP two way
valve (A), and connect it to a T-fitting (B) from the
vacuum gauge and the vacuum pump as shown.
3. Apply vacuum slowly and continuously while
watching the gauge. The vacuum should stabilize
momentarily at 0.8
2.1 kPa (0.2 0.6 in.Hg, 6 16
mmHg).
If the vacuum stabilizes (valve opens) below 0.8 kPa
(0.2 in.Hg, 0.6 mm Hg) or above 2.1 kPa (0.6 in.Hg,
16 mmHg), install a new valve and retest.
4. Move the vacuum pump hose from the vacuum
fitting to the pressure fitting, and move the vacuum
gauge hose from the vacuum side to the pressure
side (A) as shown.
5. Slowly pressurize the vapor line while watching the
gauge. The pressure should stabilize momentarily
above 1.0 kPa (0.3 in.Hg, 8 mm Hg).
• If the pressure momentarily stabilizes (valve
opens) above 1.0 kPa (0.3 in.Hg, 8 mmHg), the
valve is OK.
• If the pressure stabilizes below 1.0 kPa (0.3 in.Hg,
8 mmHg), install a new valve and retest.
03/07/29 09:26:29 61S0X050_110_0297