Honda 2004 Odyssey, Service Manual

Page: 2180 / 2459

−
−
−
−
０１
０２
０３
Ｓ０Ｘ４ＡＺ３Ｋ７９１０００８１０２４ＦＡＡＴ００
’02 Model
DTC 2-4:
Special Tools Required
YES
NO
YES
NO
23-115
A
07XAZ-SZ30100
07SAZ-TB4011A
A
B
A
B
Short to Power in Front Passenger’s
Airbag Inflator
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger’s airbag 4P
connector from the SRS main harness 4P connector
(A).
5. Connect the special tool (2 connectors) to the
SRS main harness 4P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-35).
Go to step 9.
Short to power in the front passenger’s airbag
inflator; replace the front passenger’s airbag (see
page 23-370).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver’s airbag 4P connector (A)
from the cable reel 4P connector (B).
11. Disconnect both seat belt tensioner 2P connectors
(A) from the side wire harness 2P connectors (B).
(cont’d)
Does the SRS indicator stay on?
Is DT C 2-4 indicated?
03/07/29 10:34:35 61S0X050_230_0115