Honda 2004 Odyssey, Service Manual

Page: 826 / 2459

＊０１
Ｓ０Ｘ４ＡＡ０Ｅ１０４１１３０００００ＭＥＡＴ００
→ →
14-213
Secondary Shaft Disassembly, Inspection, and Reassembly
226 N·m (23.0 kgf·m, 166 lbf·ft) 0
167 N·m (17.0 kgf·m, 123 lbf·ft)
CONICAL SPRING WASHER
IDLER GEAR
TRANSMISSION
HOUSING BEARING
THRUST NEEDLE
BEARING
THRUST NEEDLE
BEARING
NEEDLE BEARING
SECONDARY SHAFT
NEEDLE BEARING
1ST GEAR
COTTERS, 32 mm
BALL BEARING
SNAP RING
O-RINGS
2ND GEAR
THRUST NEEDLE
BEARING
COTTER RETAINER
SEALING RINGS, 25 mm
SPLINED WASHER,
38 x 56.5 mm
THRUST NEEDLE
BEARING
THRUST SHIM, 37 x 55 mm
1ST/2ND CLUTCH
ASSEMBLY
LOCKNUT (FLANGE NUT)
1. Remove the locknut, and disassemble the shaft and gears.
2. Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
3. Check clearance of the secondary shaft assembly (see page 14-214).
4. Check the splines for excessive wear and damage.
5. Check the shaft bearing surfaces for scoring, scratches, and excessive wear.
6. Check the idler gear bearing for wear and rough movement. If the bearing is worn or damaged, replace it (see
page 14-216).
7. Before installing the O-rings, wrap the shaft splines with tape to prevent damage to the O-rings.
8. Lubricate all parts with ATF during reassembly.
9. Install the conical spring washer and 38 x 56.5 splined washer in the direction shown.
Replace.
Replace.
Selective part
Selective part
Replace.
Left-hand threads
03/07/29 09:35:30 61S0X050_140_0216