Honda 2004 Odyssey, Service Manual

Page: 506 / 2459

−
−
−
−
−
−
−
−
＊０２
＊０３
０１
Ｓ０Ｘ４ＡＺ１Ａ２０３３６１４７０２２ＦＡＡＴ００
YES
NO
YES
NO
YES
NO
YES
NO
’01 Model
11-197 11-197
A (32P)
B (25P)
PCM CONNECTORS
LG1 (BRN/BLK)
PSPSW (GRN)
PSPSW (GRN)
PCM CONNECTOR A (32P)
PCM CONNECTORS
A (31P)
E (31P)
LG1 (BRN/BLK)
PSPSW(GRN)
16. Measure voltage between PCM connector
terminals A26 and B20.
Replace the PSP switch.
Go to step 17.
17. Turn the ignition switch OFF.
18. Disconnect PCM connector A (32P).
19. Check for continuity between body ground and
PCM connector terminal A26.
Repair short in the wire between the PCM
(A26) and the PSP switch.
Substitute a known-good PCM and recheck
(see page 11-5). If voltage is normal, replace the
original PCM.
1. Turn the ignition switch ON (II).
2. Measure voltage between PCM connector
terminals A26 and E20.
Go to step 3.
Go to step 6.
3. Start the engine.
4. Turn the steering wheel to the full lock position.
5. Measure voltage between PCM connector
terminals A26 and E20.
The PSP switch signal is OK.
Go to step 13.
6. Turn the ignition switch OFF.
7. Disconnect the PSP switch 2P connector.
8. Turn the ignition switch ON (II).
(cont’d)
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is ther e batter y voltage?
Is ther e continuity?
Is ther e less than 1.0 V ?
Is ther e batter y voltage?
03/07/29 09:23:13 61S0X050_110_0197