Honda 2004 Odyssey, Service Manual

Page: 1998 / 2459

０１
０２
０１
０２
Ｓ０Ｘ４Ａ００Ｊ１６１６０７５５６３２ＦＥＡＴ００
22-319
Right Slide Motor Revolution Sensor Test
1. Remove the rear side trim panel (see page 20-60).
2. Check for voltage between the No. 4 terminal and
body ground. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the RED wire.
– a short in the wire.
3. Check for voltage between the No. 4 and No. 1
terminals. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the PNK/BLK wire.
4. Turn the power sliding door main switch OFF.
5. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A17 and A2.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty right slide motor revolution sensor.
– an open or a short in the RED/BLK wire.
6. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A2 and A15.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty right slide motor revolution sensor.
– an open or a short in the LT GRN/BLK wire.
Wire side of
female terminals
Wire side of
female terminals
Wire side of female terminals
Wire side of female terminals
03/07/29 10:27:24 61S0X050_220_0321