Honda 2004 Odyssey, Service Manual

Page: 135 / 2459

０１
Ｓ０Ｘ４Ａ０８Ａ１４５０００１７６３１ＦＣＡＴ００
Cavity Wire Test condition Test: Desired result Possible cause if result is
not obtained
4-48
Cruise Control
Cruise Control Unit Input Test
CRUISE CONTROL UNIT
14P CONNECTOR
BRN
GRY
BLK
BLK/YEL
WHT/BLK
LT GRN/RED
LT GRN/BLK
LT BLU
BLU/GRN
BRN/WHT
BLU/BLK
BRN/BLK
BLU/WHT
LT GRN
SRS components are located in this area. Review the SRS component locations, 1999-2001 models (see page 23-18),
2002 model (see page 23-19), 2003-2004 models (see page 23-20), and the precautions and procedures (see page 23-
21) in the SRS before performing repairs or service.
1. Remove the driver’s dashboard lower cover (see page 20-69).
2. Disconnect the 14P connector from the cruise control unit.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, go to step 4.
4. With the 14P connector disconnected, make these input tests.
•
•
•
•
•
• 1 BRN Connect battery power Check the operation of the
magnetic clutch: Clutch
should click and output link
should be locked. Faulty actuator
Poor ground (G201)
An open in the wire
Short to ground
9 BRN/ WHT Connect battery power to
the BRN/WHT terminal and
ground to the BRN/BLK
terminal Check the operation of the
actuator motor: You should
be able to hear the motor Faulty actuator
An open in the wire
11 BRN/ BLK
Wire side of
female terminals
03/07/29 09:08:23 61S0X050_040_0048