Honda 2004 Odyssey, Service Manual

Page: 254 / 2459

＊０７
＊０８
＊０９
7-25
A
B
A
11 x 1.5 mm
76 N·m (7.8 kgf·m,
56 lbf·ft)
B
10 x 1.25 mm
49 N·m (5.0 kgf·m,
36 lbf·ft)
B
A
17. Line up the mark (A) on the connecting rod and cap,
then install the cap.
18. Apply new engine oil to the bolt threads. Torque
the bolts (B) to 20 N·m (2.0 kgf·m, 14 lbf·ft).
19. Mark the connecting rod (A) and bolt head (B) as
shown.
20. Tighten the bolt until the mark on the bolt head
lines up with the mark on the connecting rod (turn
the bolt 90°).
21. Torque the bearing cap bolts (A), then torque the
bearing cap side bolts (B). Follow the numbered
sequence shown.
NOTE: Whenever any crankshaft or connecting rod
bearing is replaced, it is necessary after
reassembly to run the engine at idling speed until it
reaches normal operating temperature, then
continue to run it for about 15 minutes.
(cont’d)
03/07/29 09:13:09 61S0X050_070_0025