Honda 2004 Odyssey, Service Manual

Page: 97 / 2459

＃ ＃
− −
＊０１
＊０２
０１
＊０３
Armature Inspection and Test
Commutator Diameter
Standard (New): 28.0
28.1 mm (1.102 1.106 in.)
Service Limit: 27.5 mm (1.083 in.)
Commutator Runout
Standard (New): 0.02 mm (0.001 in.) max.
Service Limit:
0.05 mm (0.002 in.)
4-10
Starting System
Starter Overhaul (cont’d)
A
B
1. Remove the starter (see page 4-8).
2. Disassemble the starter as shown at the beginning
of this procedure.
3. Inspect the armature for wear or damage from
contact with the permanent magnet. If there is wear
or damage, replace the armature.
4. Check the commutator (A) surface. If the surface is
dirty or burnt, resurface with emery cloth or a lathe
within the following specifications, or recondition
with
500 or 600 sandpaper (B).
5. Check the commutator diameter. If the diameter is
below the service limit, replace the armature.
6. Measure the commutator runout.
• If the commutator runout is within the service
limit, check the commutator for carbon dust or
brass chips between the segments.
• If the commutator runout is not within the service
limit, replace the armature.
03/07/29 09:07:20 61S0X050_040_0010