Honda 2004 Odyssey, Service Manual

Page: 53 / 2459

− − ―――
―――
− − −
− −
− −
− − −
− − −
±
− ±
±
± ±
± ±
±
− −
− −
− −
− −
− −
− −
Ｓ０Ｘ４Ａ００００００００００００００ＮＤＡＴ０４
Steering
Suspension
Item Measurement Qualification Standard or New Service Limit
Item Measurement Qualification Standard or New Service Limit
2-20
Standards and Service Limits
Steering wheel Rotational play measured at outside
edge
With engine
running
0 10 mm (0 0.39 in.)
Starting load measured at outside
edge
With engine
running
30 N (3.1 kgf, 6.8 lbf)
Gearbox Angle of rack guide screw loosened
from locked position
20° Max
Pump Output pressure with shut-off valve
closed
8,300 8,800 kPa (85 90 kgf/cm , 1,210 1,280 psi)
Power steering
fluid
Capacity
Use Honda Power Steering Fluid
For fluid change 0.4 (0.42 US qt)
For system
overhaul
1.1 (1.16 US qt)
Power steering
pump belt
NOTE: Adjust a
belt to the
new belt spec,
run the engine
for 5 minutes,
then readjust it
to the belt
spec.
Deflection with 98 N (10 kgf, 22 lbf)
applied mid-way between pulleys
Used belt: 13.0 16.5 mm (0.51 0.65 in.)
New belt: 8.5 11.0 mm (0.33 0.43 in.)
Tension (measured with belt tension
gauge)
Used belt: 390 540 N (40 55 kgf, 88 120 lbf)
New belt: 740 880 N (75 90 kgf, 170 200 lbf)
Wheel alignment Camber Front 0°00’ 1°
Rear 0°30’ 45’
Caster Front 2°07’ 1°
Total Toe Front 0 2 mm (0 1/16 in.)
Rear 0 2 mm (0 1/16 in.)
Front wheel turning angle Inside wheel 41°46’ 2°
Outside wheel 33°28’ (Reference)
Aluminum wheel Runout Axial 0 0.7 mm (0 0.03 in.) 2.0 mm (0.08 in.)
Radial 0 0.7 mm (0 0.03 in.) 1.5 mm (0.06 in.)
Steel wheel Runout Axial 0 1.0 mm (0 0.04 in.) 2.0 mm (0.08 in.)
Radial 0 1.0 mm (0 0.04 in.) 1.5 mm (0.06 in.)
Wheel bearing End play Front 0 0.05 mm (0 0.002 in.)
Rear 0 0.05 mm (0 0.002 in.)
2
new
used
03/07/29 09:04:36 61S0X050_020_0020