Honda 2004 Odyssey, Service Manual

Page: 2366 / 2459

−
−
−
−
−
−
−
−
＊０１
＊０２
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ８１６１ＦＡＡＴ００
’03-04 Models
DTC 81-61:
DTC 81-62:
YES
NO
YES
NO
YES
NO
YES
NO
23-301
C
RIGHT SIDE WIRE HARNESS 6P CONNECTOR C
YEL/GRN
No Signal from Front Passenger’s
Weight Sensor Unit
Non-stipulated Response Data
1. Make sure nothing is on the front passenger’s seat.
2. Calibrate the front passenger’s weight sensors unit
(see page 23-42).
3. Erase the DTC memory (see page 23-39).
4. Read the DTC (see page 23-38).
Go to step 5.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
5. Check the connection between the right side wire
harness 6P connector and the front passenger’s
weight sensor unit.
6. Erase the DTC.
7. Read the DTC.
Go to step 8.
Repair the poor connections and retest. If DTC
81-61 or 81-62 is still present, go to step 8.
8. Turn the ignition switch OFF.
9. Check the No. 11 (10A) fuse in the driver’s under-
dash fuse/relay box.
Go to step 10.
Replace the fuse, then turn the ignition switch
ON (II). If the fuse blows again, check for a short in
the No. 11 (10A) fuse circuit (dashboard wire
harness, right side wire harness).
10. Disconnect the right side wire harness 6P
connector C from the front passenger’s weight
sensor unit.
11. Turn the ignition switch ON (II).
12. Check for voltage between the No. 3 terminal of the
right side wire harness 6P connector C and body
ground. There should be battery voltage.
Go to step 17.
Go to step 13.
13. Turn the ignition switch OFF.
(cont’d)
Wire side of female terminals
Is DT C 81-61 or 81-62 indicated?
Is DT C 81-61 or 81-62 indicated?
Is the f use OK ?
Is ther e batter y voltage?
03/07/29 10:40:59 61S0X050_230_0301