Honda 2004 Odyssey, Service Manual

Page: 2224 / 2459

−
−
−
−
０１
０２
０３
Ｓ０Ｘ４ＡＺ３Ｋ７９１０００８１０９７ＦＡＡＴ００
’02 Model
DTC 9-7:
Special Tools Required
YES
NO
YES
NO
23-159
A
A
A
Faulty Right Front Impact Sensor
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Check the
connections between SRS unit connector A (18P)
and the SRS unit, and between the right engine
compartment wire harness 2P connector and the
right front impact sensor (see page 23-19), and at
the 4P connector between the SRS main harness
and the SRS floor harness.
Go to step 4.
Repair the poor connections and retest. If DTC
9-7 is still present, go to step 4.
4. Disconnect the battery negative cable, and wait for
3 minutes.
5. Disconnect the driver’s airbag 4P connector from
the cable reel 4P connector (A).
6. Disconnect the front passenger’s airbag 4P
connector from the SRS main harness 4P connector
(A).
7. Disconnect both seat belt tensioner 2P connectors
from the side wire harness 2P connectors (A).
(cont’d)
Does the SRS indicator stay on?
Ar e the connections OK ?
03/07/29 10:36:08 61S0X050_230_0159