Honda 2004 Odyssey, Service Manual

Page: 1345 / 2459

−
−
−
−
−
−
０２
１３
０１
Ｓ０Ｘ４Ａ９４Ｋ７０２０００８１３６０ＦＡＡＴ１０
YES
NO
YES
NO
YES
NO
TCS DTC 36:
19-144 19-144
ABS/TCS Components
DTC Troubleshooting (cont’d)
PCM CONNECTOR D (17P)
VREF (WHT/RED)
ABS/TCS CONTROL UNIT CONNECTOR B (16P)
VREF (WHT/RED)
PCM CONNECTOR D (17P)
THLOUT (RED/BLK)
5. Measure the voltage between the PCM connector D
(17P) terminal No. 9 and body ground.
Go to step 6.
Check for loose PCM connectors. If necessary,
substitute a known-good PCM, and recheck.
6. Measure the voltage between the ABS/TCS control
unit connector B (16P) terminal No. 2 and body
ground.
The system is OK at this time. If the problem
recurs, replace the ABS/TCS control unit.
Repair open in the wire between the PCM and
the ABS/TCS control unit.
NOTE: If the MIL or ABS indicator is ON, troubleshoot
the PGM-FI or ABS first.
1. Disconnect the PCM connector D (17P) and the
ABS/TCS control unit connector B(16P).
2. Check for continuity between the PCM connector D
(17P) terminal No. 16 and body ground.
Repair short to body ground in the wire
between the PCM and the ABS/TCS control unit.
Go to step 3.
3. Connect the PCM connector D (17P).
4. Start the engine.
Throttle Position Sensor Output
(THLOUT) Signal (’01 model)
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is ther e about 5 V ?
Is ther e about 5 V ?
Is ther e continuity?
03/07/29 09:57:54 61S0X050_190_0144