Honda 2004 Odyssey, Service Manual

Page: 2112 / 2459

＊１０
Operation Check of the Driver’s Seat Position
Sensor (’03-04 Models)
23-47
A
The driver’s seat position sensor must be checked after
any of these actions.
• Driver’s seat position sensor replacement
• Cover plate (front side of driver’s seat slide rail)
replacement
1. Make sure the ignition switch is OFF (0).
2. Make sure the driver’s seat is at its full forward
positon.
3. Connect the HDS to the DLC (A).
4. Turn the ignition switch ON (II).
5. From the tester’s Main Menu, select SRS, then Data
List, then All Data List. Select SPS. In the All Data
List.
6. Move the seat all the way forward, and mark the
seat with a line on the height outer cover where the
front riser cover meets the seat riser (using a piece
of tape). SPS should read ‘‘NEAR’’.
NOTE: It takes a few seconds for the tester to
display changes, so wait about 5 seconds between
each move.
• Move the seat back in small increments (about 5
mm) until SPS reads ‘‘NOT NEAR’’. The seat
should be approximately 25 mm from the front.
• If the SPS data does not work as described above,
check the driver’s seat position sensor or the
cover plate for damage, and replace parts as
needed.
7. Turn the ignition switch OFF, and disconnect the
HDS from the DLC.
03/07/29 10:31:13 61S0X050_230_0047