Honda 2004 Odyssey, Service Manual

Page: 2330 / 2459

−
−
−
−
０１
０２
０１
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ４２１ＸＦＡＡＴ００
’03-04 Models
DTC 42-1x (42-10 to 42-19, 42-1A to 42-1F):
Special Tools Required
YES
NO
YES
NO
23-265
A
A
A
No Signal from the Right Front Impact
Sensor
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Check the
connections between SRS unit connector A (28P)
and the SRS unit, between the engine
compartment right wire harness 2P connector and
the right front impact sensor (see page 23-20), and
at connectors C851 and C205.
Go to step 4.
Repair the poor connections and retest. If DTC
42-1x is still present, go to step 4.
4. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
5. Disconnect the driver’s airbag 4P connector from
the cable reel (A).
6. Disconnect the front passenger’s airbag 4P
connector from the SRS main harness (A).
7. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
(cont’d)
Does the SRS indicator stay on?
Ar e the connections OK ?
03/07/29 10:39:38 61S0X050_230_0265