Honda 2004 Odyssey, Service Manual

Page: 466 / 2459

−
−
−
−
−
−
−
＊０１
０１
０２
Ｓ０Ｘ４ＡＺ１Ｋ７７１０００９１２９８ＦＡＡＴ００
DTC P1298 ’01 Model:
YES
NO
YES
NO
YES
NO
11-157
ELD 3P CONNECTOR
IG1 (BLK/YEL)
ELD 3P CONNECTOR
ELD
(GRN/RED)
JUMPER WIRE
PCM CONNECTOR E (31P)
ELD (GRN/RED)
ELD Circuit High
Voltage
1. Reset the PCM (see page 11-4).
2. Start the engine.
3. Turn on the headlights.
Go to step 4.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ELD and the PCM.
4. Turn the ignition switch and headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P
connector terminal No. 1.
Go to step 8.
Check the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse in the driver’s under-dash
fuse/relay box. If the fuse is OK, repair open in the
wire between the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse and the ELD.
8. Turn the ignition switch OFF.
9. Connect ELD 3P connector terminal No. 3 to body
ground with a jumper wire.
10. Disconnect PCM connector A (32P).
11. Check for continuity between body ground and
PCM connector terminal E19.
Go to step 12.
Repair open in the wire between the PCM
(E19) and the ELD.
(cont’d)
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is DT C P1298 indicated?
Is ther e batter y voltage?
Is ther e continuity?
03/07/29 09:22:48 61S0X050_110_0157