Honda 2004 Odyssey, Service Manual

Page: 1414 / 2459

１２
０１
Ｓ０Ｘ４Ａ００Ｊ５４４０００５５６５１ＫＢＡＴ００
20-49 20-49
Sliding Door Glass Replacement
A
B
A
C
B
C
C
18. Use suction cups (A) to hold the rear window over
the opening, align it with the alignment marks (B)
you made in step 12, and set it down on the
adhesive. Lightly push on the rear window until its
edges are fully seated on the adhesive all the way
around. Do not open or close the doors until the
adhesive is dry.
19. Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a painted
surface or the rear window, use a soft shop towel
dampened with alcohol.
20. Let the adhesive dry for at least 1 hour, then spray
water over the rear window and check for leaks.
Mark the leaking areas, let the rear window dry,
then seal with sealant. Let the vehicle stand for at
least 4 hours after rear window installation. If the
vehicle has to be used within the first 4 hours, it
must be driven slowly.
21. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
• Slam the doors with all the windows rolled up.
• Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
NOTE:
• Put on gloves to protect your hands.
• Use seat covers to avoid damaging any surfaces.
• Wear eye protection while cutting the glass adhesive
with piano wire.
1. Remove the sliding door panel (see page 20-13).
2. Remove the upper seal (A) and molding (B) from
the edge of the glass (C). If necessary, cut the upper
seal and molding with a utility knife.
(cont’d)
03/07/29 10:01:33 61S0X050_200_0051