Honda 2004 Odyssey, Service Manual

Page: 1220 / 2459

０１
Ｓ０Ｘ４ＡＺ４Ｄ１４３０００１４７３１ＭＡＡＴ００
’99-01 Models
19-19
Rear Drum Brake Inspection
9.0 N·m (0.9 kgf·m, 6.5 lbf·ft)
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
SELF-ADJUSTER
LEVER
TENSION PIN
FLANGE BOLTS
10 x 1.25 mm
39 N·m (4.0 kgf·m,
29 lbf·ft)
BACKING PLATE
ADJUSTER BOLT
UPPER RETURN SPRING
PARKING BRAKE LEVER
U-CLIP
LOWER RETURN SPRING
SELF-ADJUSTER
SPRING
RETAINER SPRING
BRAKE SHOE
WHEEL CYLINDER
PIVOT PIN
CONNECTING ROD
THERMO CLIP
ADJUSTER NUT
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
• Avoid breathing dust particles.
• Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
NOTE:
• Contaminated brake linings or drums reduce stopping ability.
• Block the front wheels before raising the rear of the vehicle.
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations (see page 1-15).
2. Release the parking brake, and remove the rear brake drum (see page 18-22).
(cont’d)
Marked left and right.
Check for lack of
lubrication between
backing plate and
brake shoes.
Check ratchet teeth
for wear and damage.
Check for weakness
and damage.
Marked left and right.
Replace.
Check for weakness
and damage.
Check for weakness
and damage.
Install securely on
tension pin.
If brake shoes are to be
reused, mark and reassemble
in same position.
Inspect for leakage.
03/07/29 09:53:58 61S0X050_190_0019