Honda 2004 Odyssey, Service Manual

Page: 463 / 2459

−
−
−
−
−
−
−
０２
０１
Ｓ０Ｘ４ＡＺ１Ｋ７７１０００９１２９７ＦＡＡＴ００
YES
NO
YES
NO
YES
NO
DTC P1297 ’01 Model:
11-154 11-154
PGM-FI System
DTC Troubleshooting (cont’d)
PCM CONNECTOR A (32P)
ELD (GRN/RED)
ELD 3P CONNECTOR
ELD (GRN/RED)
8. Turn the ignition switch OFF.
9. Disconnect PCM connector A (32P).
10. Check for continuity between body ground and
PCM connector terminal A30.
Repair short in the wire between the PCM
(A30) and the ELD.
Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
1. Reset the PCM (see page 11-4).
2. Start the engine.
3. Turn on the headlights.
Go to step 4.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ELD and the PCM.
4. Turn the ignition switch and the headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P
connector terminal No. 3.
Replace the ELD.
Go to step 8.
ELD Circuit Low
Voltage
Wire side of female terminals
Wire side of female terminals
Is ther e continuity?
Is DT C P1297 indicated?
Is ther e about 5 V ?
03/07/29 09:22:46 61S0X050_110_0154