Honda 2004 Odyssey, Service Manual

Page: 996 / 2459

１５
０６
１６
＊０１
− −
−
14-383
C
D
B
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
A
10 x 1.25 mm
39 N·m (4.0 kgf·m,
29 lbf·ft)
A
B
C
F
E
G
D
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
C
B
12 x 1.25 mm
59
69 N·m (6.0 7.0 kgf·m,
43 51 lbf·ft)
F
G
E
D
12 x 1.25 mm
78 N·m (7.0 kgf·m,
51 lbf·ft)
A
C
D
A
E
C
D
B
E
10 x 1.25 mm
54 N·m (5.5 kgf·m,
40 lbf·ft) 10 x 1.25 mm
33 N·m (3.4 kgf·m,
25 lbf·ft)
23. Install the steering gearbox mounting bolt (A) and
the power steering fluid line bracket bolts (B).
24. Install the power steering fluid return hose clamp
(C) on the bracket (D).
25. Install the control lever (A) with the shift cable (B)
on the control shaft (C). Do not bend the shift cable
excessively.
26. Install the lock bolt (D) with a new lock washer (E),
then bend the lock washer tab against the bolt.
27. Install the shift cable cover (F), then install the shift
cable holder (G) on the shift cable cover.
NOTE: To prevent damage to the control lever joint,
be sure to install the shift cable holder after
installing the shift cable cover to the torque
converter housing.
28. Install the ball joints on each lower arms (A) with
the castle nuts (hex nuts) (B) and spring pins (C).
29. Install the nut (D) to the ball joint pin (E) on the
stabilizer link (F), then use a 6 mm Allen wrench (G),
and tighten the nut to the specified torque.
30. Install the exhaust pipe A and the three way
catalytic converter (B) assembly.
31. Connect the oxygen sensor connectors (C), then
install them on their connector brackets (D).
Install the harnesses on the clamps (E).
(cont’d)
Replace. Replace.
03/07/29 09:40:35 61S0X050_140_0386