Honda 2004 Odyssey, Service Manual

Page: 1114 / 2459

０５
＊０１
＊０１
Ｓ０Ｘ４Ａ００Ｅ１６２３６５０００００ＫＡＡＴ００
16-17 16-17
Intermediate Shaft Removal
B
A
12 x 1.25 mm
78 N·m
(8.0 kgf·m,
58 lbf·ft)
12 x 1.5 mm
108 N·m
(11.0 kgf·m,
80.0 lbf·ft)
A
24 x 1.5 mm
245 N·m (25.0 kgf·m, 181 lbf·ft)
B
B
A
C
7. Install the stabilizer link (A) on the damper (B).
8. Install a new spindle nut (A), then tighten the nut.
After tightening, use a drift to stake the spindle nut
shoulder (B) against the driveshaft.
9. Clean the mating surfaces of the brake disc and the
front wheel, then install the front wheel with the
wheel nuts.
10. Turn the front wheel by hand, and make sure there
is no interference between the driveshaft and
surrounding parts.
11. Tighten the flange bolts and the self-locking nut
with the vehicle’s weight on the damper.
12. Refill the transmission with recommended fluid:
• 4-speed 1999-2001 automatic transmission (see
page 14-137).
• 5-speed 2002-2004 automatic transmission (see
page 14-368).
13. Check the front wheel alignment, and adjust it if
necessary (see page 18-5).
1. Drain the transmission fluid:
• 4-speed 1999-2001 automatic transmission (see
page 14-137).
• 5-speed 2002-2004 automatic transmission (see
page 14-368).
2. Remove the right driveshaft (see page 16-3).
3. Remove the three dowel bolts (A).
4. Remove the intermediate shaft (B) from the
differential. Hold the intermediate shaft horizontal
until it is clear of the differential to prevent damage
to the differential oil seal (C).
03/07/29 09:47:32 61S0X050_160_0017