Honda 2004 Odyssey, Service Manual

Page: 1033 / 2459

− −
＊０４
＊０５
＊０１
＊０２
Ｓ０Ｘ４ＡＡ１Ｅ１０４１０４４５００１ＭＣＡＴ００
Standard: 84.6 85.6 mm (3.33 3.37 in.)
PARK LEVER STOP
Mark Part Number L1 L2
14-420 14-420
Transmission End Cover
End Cover, 3rd Gear, Idler Gear, and
3rd Clutch Removal (cont’d) Park Lever Stop Inspection and
Adjustment
07736-A01000B or
07736-A01000A
A
D
C
B
A
B
D
A
C
E
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
L1
L2
E
15. Remove the 3rd clutch assembly using the special
tool and a commercially available 3/8-16’’ slide
hammer (A).
16. Remove the splined washer, thrust needle bearing,
countershaft 3rd gear, needle bearing, and thrust
needle bearing from the countershaft.
17. Remove the mainshaft 3rd gear (A), secondary
shaft idler gear (B), and park gear (C) with a puller
(D).
18. Remove the park pawl, park pawl spring, park pawl
shaft, and stop shaft.
19. Remove the park lever from the control shaft.
20. Remove A/T clutch pressure control solenoid
valves A and B.
1. Set the park lever (A) in the P position.
2. Measure the distance (B) between the park pawl
shaft (C) and the park lever roller pin (D).
3. If the measurement is out of tolerance, select and
install the appropriate park lever stop (E) from the
table.
1 24537-PA9-003 11.00 mm
(0.433 in.) 11.00 mm
(0.433 in.)
2 24538-PA9-003 10.80 mm
(0.425 in.) 10.65 mm
(0.419 in.)
3 24539-PA9-003 10.60 mm
(0.417 in.) 10.30 mm
(0.406 in.)
4. After replacing the park lever stop, make sure the
distance is within tolerance.
03/07/29 09:45:43 61S0X050_140_0423