Honda 2004 Odyssey, Service Manual

Page: 462 / 2459

−
−
−
−
−
−
−
Ｓ０Ｘ４Ａ００Ｋ７７１０００９１１０７ＦＡＡＴ００
０１
Ｓ０Ｘ４ＡＺ６Ｋ７７１０００９１２９７ＦＡＡＴ００
DTC P1107:
DTC P1108:
DTC P1297 ’99-00, ’02-04 Models:
YES
NO
YES
NO
YES
NO
11-153 11-153
ELD 3P CONNECTOR
ELD (GRN/RED)
BARO Sensor Circuit Low Voltage
BARO Sensor Circuit High
Voltage
ELD
Circuit Low Voltage
1. Reset the PCM (see page 11-4).
2. Turn the ignition switch ON (II).
Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
Intermittent failure, system is OK at this
time.
1. Reset the PCM (see page 11-4).
2. Start the engine.
3. Turn on the headlights.
Go to step 4.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ELD and the PCM.
4. Turn the ignition switch and the headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P
connector terminal No. 3.
Replace the ELD.
Go to step 8.
(cont’d)
Wire side of female terminals
Is DT C P1107 or P1108 indicated? Is DT C P1297 indicated?
Is ther e about 5 V ?
03/07/29 09:22:45 61S0X050_110_0153