Honda 2004 Odyssey, Service Manual

Page: 2320 / 2459

−
−
−
−
＊０１
０１
０２
Ｓ０Ｘ４ＡＳＩＫ７９１０００Ｒ３２３ＸＦＡＡＴ００
’03-04 Models
DTC 32-3x (32-30 to 32-39, 32-3A to 32-3F):
Special Tools Required
YES
NO
YES
NO
23-255
07XAZ-S1A0200
07SAZ-TB4011A
A
A
B
Short to Another Wire or Decreased
Resistance in Front Passenger’s Side Airbag
Inflator
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
• SRS short canceler 070AZ-SAA0100
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the right side wire harness 2P
connector (A) from the front passenger’s side
airbag.
5. Connect the special tool (2 connector) to the
right side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Go to step 9.
Short to another wire in the front passenger’s
side airbag inflator; replace the front passenger’s
side airbag (see page 23-372).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
11. Disconnect SRS unit connector B (28P) from the
SRS unit.
(cont’d)
Does the SRS indicator stay on?
Is DT C 32-3x indicated?
03/07/29 10:39:30 61S0X050_230_0255