Honda 2004 Odyssey, Service Manual

Page: 2142 / 2459

−
−
−
−
−
０２
０４
０１
Ｓ０Ｘ４ＡＺ４Ｋ７９１０００８１０２３ＦＡＡＴ００
YES
NO
YES
NO
’99-01 Models
DTC 2-3:
23-77 23-77
A
SRS MAIN HARNESS 18P CONNECTOR
07TAZ-SZ5011A
07SAZ-TB4011A
A
11. Disconnect the SRS main harness 18P connector
(A) from the SRS unit. Do not disconnect the special
tool from the SRS main harness 2P connector.
12. Check resistance between the No. 10 and No. 14
terminals of the SRS main harness 18P connector.
There should be 2.0
3.0 .
Faulty SRS unit or poor contact at the SRS
unit connector (18P). Check the connection; if the
connection is OK, replace the SRS unit (see page
23-382).
Open or increased resistance in the SRS main
harness; replace the SRS main harness.
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger’s airbag 2P
connector from the SRS main harness 2P connector
(A).
5. Connect the special tool (2 connector) to the SRS
main harness 2P connector.
(cont’d)
Short to Another Wire or Decreased
Resistance in Front Passenger’s Airbag
Inflator
Wire side of female terminals
Is the r esistance as specif ied?
Does the SRS indicator stay on?
03/07/29 10:33:01 61S0X050_230_0077