Honda 2004 Odyssey, Service Manual

Page: 1144 / 2459

０１
０２
Ｓ０Ｘ４Ａ００Ｆ００００００５７１０１ＫＤＡＴ００
Removal
17-25
Steering Column Removal and Installation
MAXIMUM UPPER POSITION
NEUTRAL POSITION
MAXIMUM LOWER POSITION
8 mm (5/16 in.)
FULL STROKE: 23 mm (0.9 in.)
A
B
B
A
C
A
16 N·m (1.6 kgf·m, 12 lbf·ft)
22 N·m
(2.2 kgf·m, 16 lbf·ft)
D
E
F
22 N·m
(2.2 kgf·m, 16 lbf·ft)
SRS components are located in this area. Review the SRS component locations, ’99-01 models (see page 23-18),
’02 model (see page 23-19), ’03-04 models (see page 23-20), and the precautions and procedures (see page 23-21) in
the SRS before performing repairs or service.
1. Record the radio station presets, and disconnect the battery.
2. Remove the driver’s airbag, steering wheel, and cable reel (see page 23-368).
3. Set the column shaft (A) in the neutral position by pulling up the steering column to uppermost position, then
lower it 8 mm (0.31 in.). Tighten the tilt lever (B).
4. Remove the column covers (A).
5. Move the shift lever (B) to the N position, and remove the shift cable from the column, and set it aside.
6.
7.
8. Remove the steering joint cover (D).
9. Disconnect the steering joint (E), and remove it from the column shaft.
10. Remove the steering column (F) by removing the attaching nuts and bolts.
(cont’d)
03/07/29 09:49:06 61S0X050_170_0025
Disconnect the ignition switch connectors and disconnect the harness clips.
Remove the combination switch assembly (C) from the steering column shaft by disconnecting the connectors and
removing the screws.