Honda 2004 Odyssey, Service Manual

Page: 803 / 2459

− −
＊０４
＊０１
＊０２
Ｓ０Ｘ４ＡＡ０Ｅ１０４１０４４５００１ＭＣＡＴ００
Standard: 84.6 85.6 mm (3.33 3.37 in.)
PARK LEVER STOP
Mark Part Number L1 L2
14-190 14-190
Transmission End Cover
End Cover and Idler Gear Removal
(cont’d) Park Lever Stop Inspection and
Adjustment
C
D
F B
A
E
C
E
A
D
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
B
L1
L2
E
9. Remove the mainshaft idler gear (A) and the
secondary shaft idler gear (B) with a puller (C).
10. Remove the bearing hub (D) with the puller from
the countershaft, then remove the countershaft
idler gear (E) and bearings.
11. Remove the park gear (F) with the puller.
12. Remove the park pawl, spring, shaft, and shaft stop.
13. Remove the park lever from the control shaft.
14. Remove the line bolts, then remove the ATF cooler
lines.
1. Set the park lever (A) in the P position.
2. Measure the distance (B) between the park pawl
shaft (C) and the park lever roller pin (D).
3. If the measurement is out of tolerance, select and
install the appropriate park lever stop (E) from the
table.
1 24537-PA9-003 11.00 mm
(0.433 in.) 11.00 mm
(0.433 in.)
2 24538-PA9-003 10.80 mm
(0.425 in.) 10.65 mm
(0.419 in.)
3 24539-PA9-003 10.60 mm
(0.417 in.) 10.30 mm
(0.406 in.)
4. After replacing the park lever stop, make sure the
distance is within tolerance.
03/07/29 09:34:19 61S0X050_140_0193