Honda 2004 Odyssey, Service Manual

Page: 618 / 2459

＊０６
How to Troubleshoot Circuits at the PCM Clear A/T DTCs, and PCM Reset Procedures
Special Tools Required
14-5
C
B
07SAZ-001000A
A
07SAZ-001000A
Backprobe set 07SAZ-001000A (two required)
1. Pull back the carpet from passenger’s side of the
center lower console to expose the PCM.
2. Inspect the circuit on the PCM, according to the
DTC troubleshooting, with the special tools and a
digital multimeter.
3. Connect the backprobe adapters (A) to the stacking
patch cords (B), and connect the cords to a
multimeter (C).
4. Using the wire insulation as a guide for the
contoured tip of the backprobe adapter, gently slide
the tip into the connector from the wire side until it
touches the end of the wire terminal.
5. If you cannot get to the wire side of the connector
or the wire side is sealed, disconnect the connector
and use the tester probe to probe the connectors
from the terminal side. Do not force the probe into
the connector.
1. Connect the Scan Tool or the HDS to the DLC.
2. Turn the ignition switch ON (II).
3. Clear the DTC(s) with the Scan Tool or the HDS.
NOTE: You can also reset the memory by removing
the No. 13 fuse in the passenger’s under-dash fuse/
relay box for more than 10 seconds. If you do, you
need to do the following:
• Get the customer’s radio and navigation (if
equipped) anti-theft code, and write down the
radio and navigation presets.
• Enter the radio and navigation (if equipped) anti-
theft code, reset the preset stations, and set the
clock.
• Do the idle learn procedure (see page 11-202).
(cont’d)
03/07/29 09:29:14 61S0X050_140_0008