Honda 2004 Odyssey, Service Manual

Page: 709 / 2459

−
−
−
−
−
−
−
−
−
−
＊０１
０１
０２
Ｓ０Ｘ４ＡＡ３Ｋ７７１０００９０７１５ＦＡＡＴ００
2001 Model
DTC P0715:
YES
NO
YES
NO
YES
NO
YES
NO
14-96
Automatic Transmission
DTC Troubleshooting (cont’d)
MAINSHAFT SPEED SENSOR CONNECTOR
PCM CONNECTOR C (22P)
NM SG (WHT) NM (RED)
PCM CONNECTOR C (22P)
NM SG (WHT) NM (RED)
Problem in Mainshaft Speed
Sensor Circuit
NOTE: Record all freeze data and review General
Troubleshooting Information (see page 14-3) before
you troubleshoot.
Code P0715 (code 15) on the PCM doesn’t always mean
there’s an electrical problem in the mainshaft or
countershaft speed sensor circuit; code P0715 (code 15)
may also indicate a mechanical problem in the
transmission. Any problem causing irregular
countershaft to mainshaft speed difference can cause
this code.
1. Check the mainshaft and countershaft speed
sensor installation.
Go to step 2.
Reinstall and recheck.
2. Disconnect the mainshaft speed sensor connector
(2P).
3. Measure the mainshaft speed sensor resistance at
the sensor connector.
Go to step 4.
Replace the mainshaft speed sensor (see
page 14-134).
4. Disconnect PCM connector C (22P).
5. Check for continuity between PCM connector
terminal C6 and body ground, and between
terminal C7 and body ground.
Repair short in the wires between PCM
connector terminals C6 and C7, and the mainshaft
speed sensor.
Go to step 6.
6. Connect the mainshaft speed sensor connector.
7. Measure the resistance between PCM connector
terminals C6 and C7.
Run the Electrical Troubleshooting Flowchart
for code P0720 (code 9). Check for loose terminal fit
in the PCM connectors. If necessary, substitute a
known-good PCM and recheck.
Go to step 8.
Terminal side of male terminals
Wire side of female terminals
Wire side of female terminals
Ar e the mainshaf t and the counter shaf t speed
sensor s installed pr oper ly?
Is ther e 400 600 ?
Is ther e continuity?
Is ther e 400 600 ?
03/07/29 09:31:15 61S0X050_140_0099