Honda 2004 Odyssey, Service Manual

Page: 1389 / 2459

＊０１
２２
２３
Ｓ０Ｘ４Ａ００Ｊ１６１２６７０００００ＭＢＡＴ２０
20-24
Doors
Front Door Position Adjustment
A
D
C
F
D
8 x 1.25 mm
29 N·m
(3.0 kgf·m,
22 lbf·ft)
G
8 x 1.25 mm
29 N·m
(3.0 kgf·m,
22 lbf·ft)
D
8 x 1.25 mm
29 N·m
(3.0 kgf·m,
22 lbf·ft)
F
A
G
8 x 1.25 mm
29 N·m (3.0 kgf·m,
22 lbf·ft)
A
E
8 x 1.25 mm
29 N·m (3.0 kgf·m, 22 lbf·ft)
A
A
NOTE: Check for a flush fit with the body, then check for
equal gaps between the front, rear, and bottom door
edges and the body. Check that the door and body
edges are parallel.
1. Place the vehicle on a firm, level surface when
adjusting the doors.
2.
•
with a shop towel (C).
• Loosen the door mounting bolts (D), and move
the door up or down as necessary to equalize the
gaps, and in or out until it’s flush with the body.
3. If necessary, replace the hinge mounting bolt (E)
with the adjusting bolt (P/N 90101-SZ3-000) made
specifically for door adjustment, then adjust at the
hinges (F):
Loosen the hinge mounting bolts (E, G) slightly,
and move the door backward or forward, up or
down as necessary to equalize the gaps.
4. Check that the door and body edges are parallel. If
necessary, adjust the door cushions (A) to make the
rear of the door flush with the body.
5. Apply multipurpose grease to the pivot portions of
the hinges indicated by the arrows.
6. Apply touch-up paint to the hinge mounting bolts,
and around the hinges.
7. Check for water leaks (see step 7 on page 20-23).
8. Test-drive and check for wind noise.
03/07/29 10:00:12 61S0X050_200_0026
Support the door with a jack (B) that is padded
Adjust the door (A):