Honda 2004 Odyssey, Service Manual

Page: 2448 / 2459

０３
０５
Installation (’99-01 Models) Installation (’02 Model)
23-383
C
A
B
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
B
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
C
A
1. Install the new SRS unit (A) with new Torx bolts (B),
then connect the SRS main harness 18P connector
(C) to the SRS unit; push it into position until it
clicks.
NOTE: When tightening the Torx bolts to the
specified torque after replacement, be careful to
turn them in so that their heads rest squarely on the
brackets.
2. Reinstall the center lower pocket (see page 20-67).
3. Reconnect the airbag connectors (see page 23-29),
and seat belt tensioner connectors (see page 23-29).
4. Reconnect the battery negative cable.
5. After installing the SRS unit, confirm proper system
operation. Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
1. Install the new SRS unit (A) with Torx bolts (B), then
connect the connectors (C) to the SRS unit; push it
into position until it clicks.
NOTE: When tightening the Torx bolts to the
specified torque after replacement, be careful to
turn them in so that their heads rest squarely on the
brackets.
2. Reinstall the dashboard center lower pocket (see
page 20-67).
3. Reconnect the driver’s and front passenger’s airbag
connectors (see page 23-30).
4. Reconnect the side airbag connectors (see page 23-
31).
5. Reconnect both seat belt tensioner connectors (see
page 23-31).
6. Reconnect the battery negative cable.
7. Initialize the OPDS unit (see page 23-40).
8. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
(cont’d)
03/07/29 10:42:55 61S0X050_230_0383