Honda 2004 Odyssey, Service Manual

Page: 940 / 2459

−
−
−
−
−
−
−
０３
＊０２
０４
YES
NO
YES
NO
YES
NO
14-327
B (25P) D (16P)
LG1 (BRN/YEL) LG2 (BRN/YEL)
LC (YEL)
PCM CONNECTORS
TORQUE CONVERTER CLUTCH SOLENOID
VALVE CONNECTOR
B (25P) D (16P)
LG1 (BRN/YEL) LG2 (BRN/YEL)
VB SOL (BLK/YEL)
PCM CONNECTORS
8. Disconnect the torque converter clutch solenoid
valve connector (2P).
9. Check for continuity between PCM connector
terminals D1 and B20 or B22.
Repair short to ground in the wire between
PCM connector terminal D1 and the torque
converter clutch solenoid valve.
Go to step 10.
10. Measure torque converter clutch solenoid valve
resistance at the solenoid valve connector.
Check for an open in the wires between PCM
connector terminal D1 and the torque converter
clutch solenoid valve, and between torque
converter clutch solenoid valve connector terminal
No. 1 and ground (G101).
Replace the torque converter clutch solenoid
valve (see page 14-357).
11. Turn the ignition switch ON (II).
12. Measure the voltage between PCM connector
terminals D5 and B20 or B22.
Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
Check for blown No. 6 (15A) fuse in the
driver’s under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between PCM connector
terminal D5 and the driver’s under-dash fuse/relay
box.
Wire side of female terminals
Terminal side of male terminals
Wire side of female terminals
Is ther e continuity?
Is the r esistance 12 25 ?
Is ther e batter y voltage?
03/07/29 09:39:02 61S0X050_140_0330