Honda 2004 Odyssey, Service Manual

Page: 1404 / 2459

０１
＊０１
０３
Ｓ０Ｘ４Ａ００Ｊ５４４０００６５５０１ＫＢＡＴ００
20-39
Windshield Replacement
A
B
A
B
A
B
F
A D
F
A
D C
E
A
A
NOTE:
• Put on gloves to protect your hands.
• Use seat covers to avoid damaging any surfaces.
• Wear eye protection while cutting the glass adhesive
with piano wire.
1. Remove these items:
• Rearview mirror (see page 20-36)
• Windshield wiper arms and cowl cover (see page
22-231)
2. Remove the molding (A) from the edge of the
windshield (B). If necessary, cut the molding with a
utility knife.
3. If the old windshield will be reinstalled, make
alignment marks across the glass and body with a
grease pencil.
4. Pull down the front portion of the headliner (see
page 20-62). Take care not to bend the headliner
excessively, or you may crease or break it.
5. Apply protective tape (A) along the edge of the
dashboard (B) and body as shown. Using an awl,
make a hole through the rubber dam (C), adhesive
(D), and dashboard seal (E) from inside the vehicle.
Push a piece of piano wire (F) through the hole, and
wrap each end around a piece of wood.
6. With a helper on the outside, pull the piano wire (A)
back and forth in a sawing motion. Hold the piano
wire as close to the windshield as possible to
prevent damage to the body and dashboard.
Carefully cut through the rubber dam and adhesive
around the entire windshield.
7. Carefully remove the windshield.
(cont’d)
03/07/29 10:00:24 61S0X050_200_0041