Honda 2004 Odyssey, Service Manual

Page: 469 / 2459

−
−
−
−
−
−
−
−
−
−
−
０１
０２
Ｓ０Ｘ４ＡＺ１Ｋ７７１０００９１３６１ＦＡＡＴ００
＋
＋
−
−
＋ −
＋ −
DTC P1361 ’01 Model:
DTC P1362 ’01 Model:
DTC P1366 ’01 Model:
DTC P1367 ’01 Model:
YES
NO
YES
NO
YES
NO
11-160
PGM-FI System
DTC Troubleshooting (cont’d)
TDC1/TDC2 SENSOR 4P CONNECTOR
TDC1
TDC2
TDC1
TDC2
TDC1/TDC2 SENSOR 4P CONNECTOR
TDC1
TDC1
TDC2
TDC2
TDC Sensor 1 Circuit
Intermittent Interruption
TDC Sensor 1 Circuit
No Signal
TDC Sensor 2 Circuit
Intermittent Interruption
TDC Sensor 2 Circuit
No Signal
1. Reset the PCM (see page 11-4).
2. Start the engine.
Go to step 3.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the TDC1/TDC2 sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the TDC1/TDC2 sensor 4P connector.
5. Measure resistance between the terminals of
indicated sensor (see table).
TDC1 P1361 1 A11 GRN
P1362 2 A23 RED
TDC2 P1366 3 A10 YEL
P1367 4 A22 BLK
Go to step 6.
Replace the TDC1/TDC2 sensor
(see page 6-60).
6. Check for continuity to body ground on both
terminals of the indicated sensor individually.
Replace the TDC1/TDC2 sensor
(see page 6-60).
Go to step 7.
7. Reconnect the TDC1/TDC2 sensor 4P connector.
8. Disconnect PCM connector A (31P).
SENSOR SENSOR
TERMINAL
PCM
TERMINAL
WIRE
COLOR
DTC
Terminal side of male terminals
Terminal side of male terminals
Is DT C P1361, P1362, P1366, or P1367
indicated?
Is ther e 1,850 2,450 ?
Is ther e continuity?
03/07/29 09:22:50 61S0X050_110_0160