Honda 2004 Odyssey, Service Manual

Page: 1072 / 2459

− −
＊０４
＊０５
＊０６
＊０７
1st-hold Clutch Plate B-to-Top-disc Clearance
Service Limit: 0.5
0.9 mm (0.020 0.035 in.)
14-459
C
A
B
C
B
A
07GAE-PG40200 or
07GAE-PG4020A
07LAE-PX40100 or
07HAE-PL50101
07LAE-PX40100
A
B
5. Check the 1st-hold clutch plate-to-top-disc
clearance; starting with a clutch plate, alternately
install the clutch plate and discs in the 1st-hold
clutch drum, then install the 1st-hold clutch plate.
6. Measure the 1st-hold clutch clearance between the
1st-hold clutch plate B and the top disc (A) with a
feeler gauge (C) while pressing the 1st-hold clutch
plate B down. Take measurements in at least three
places, and use the average as the actual clearance.
7. If the clearance is out of standard, replace the 1st-
hold clutch plates and discs as a set, and recheck.
8. Install the return spring (A) and spring retainer (B),
and position the snap ring (C) on the retainer.
9. Install the special tools on the clutch assembly.
10. Be sure the special tool (A) is adjusted to have full
contact with the spring retainer (B) on the 4th, 5th,
and 1st clutches.
(cont’d)
03/07/29 09:46:10 61S0X050_140_0462