Honda 2004 Odyssey, Service Manual

Page: 1015 / 2459

＊０１
Ｓ０Ｘ４ＡＡ１Ｅ１０４１０７０００００ＦＣＡＴ００
Cavity Wire Color Test Condition Test: Desired Result Possible Cause
(If result is not obtained)
14-402
A/T Gear Position Indicator
Indicator Input Test
GAUGE ASSEMBLY CONNECTORS
B (22P)
C (16P)
SRS components are located in this area. Review the SRS component locations, 2002 model (see page 23-19), 2003-2004 models (see page 23-
20), and the precautions and procedures (see page 23-21) in the SRS before performing repairs or service.
1. Remove the gauge assembly from the dashboard, then disconnect the gauge assembly B (22P) and C (16P) connectors.
2. Inspect the connectors and connector terminals to be sure they are all making good contact.
• If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the gauge assembly B (22P) and C (16P) connectors.
– If a test indicates a problem, find a correct the cause, then recheck the system.
– If all the input tests prove OK, but the indicator is faulty, replace the printed circuit board.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
B11 YEL Ignition switch ON (II) Check for voltage to ground:
There should be battery voltage. Blown No. 9 (10A) fuse in the driver’s
under-dash fuse/relay box
An open in the wire
B16 BLK Under all conditions Check for continuity to ground:
There should be continuity. Poor ground (G503)
An open in the wire
B22 RED/BLK Headlights ON Check for voltage to ground:
There should be battery voltage. Blown No. 10 (15A) fuse in the
passenger’s under-dash fuse/relay box
An open in the wire
C4 WHT Ignition switch ON (II)
and shift lever in R Check for voltage to ground:
There should be 1 V or less.
There should be no battery voltage
in any other shift lever position. Faulty transmission range switch
An open in the wire
C5 BRN Ignition switch ON (II)
and shift lever in 1
C6 RED Ignition switch ON (II)
and shift lever in D3
C7 BLU Ignition switch ON (II)
and shift lever in 2
C12 GRN/BLK Ignition switch ON (II)
and shift lever in D Check for voltage to ground:
There should be battery voltage. Faulty transmission range switch
Faulty PCM
An open in the wire
C13 YEL Ignition switch ON (II)
and shift lever in D Check for voltage to ground:
There should be 1 V or less.
There should be no battery voltage
in any other shift lever position. Faulty transmission range switch
An open in the wire
C15 BLK/BLU Shift lever in P Check for continuity to ground:
There should be no continuity in any
other shift lever position. Faulty transmission range switch
An open in the wire
C16 RED/BLK Ignition switch ON (II)
and shift lever in N Check for voltage to ground:
There should be 1 V or less.
There should be battery voltage in
any other shift lever position.
Wire side of female terminals
03/07/29 09:45:28 61S0X050_140_0405