Honda 2004 Odyssey, Service Manual

Page: 28 / 2459

６１
６２
Ｓ０Ｘ４Ａ００００００００００００００ＢＡＡＴ６０
Frame Hoist
Safety Stands
Floor Jack
1-15
Lift and Support Points
A
B C
A
C
B
C
NOTE: If you are going to remove heavy components
such as suspension or the fuel tank from the rear of the
vehicle, first support the front of the vehicle with tall
safety stands. When substantial weight is removed
from the rear of the vehicle, the center of gravity can
change and cause the vehicle to tip forward on the hoist.
1. Position the hoist lift blocks (A), or safety stands,
under the vehicle’s front support points (B) and rear
support points (C).
2. Raise the hoist a few inches, and rock the vehicle
gently to be sure it is firmly supported.
3. Raise the hoist to full height, and inspect the lift
points for solid contact with the lift blocks.
To support the vehicle on safety stands, use the same
support points (B and C) as for a frame hoist. Always
use safety stands when working on or under any
vehicle that is supported only by a jack.
1. When lifting the front of the vehicle, set the parking
brake. When lifting the rear of the vehicle, put the
shift lever in the P position.
2. Block the wheels that are not being lifted.
3. Position the floor jack under the front jacking
bracket (A) or rear jacking bracket (B), center the
jack lift platform (C), on the jacking bracket and jack
up the vehicle high enough to fit the safety stands
under it.
4. Position the safety stands under the support points
and adjust them so the vehicle will be level.
5. Lower the vehicle onto the stands.
03/07/29 09:03:20 61S0X050_010_0015