Honda 2004 Odyssey, Service Manual

Page: 1088 / 2459

０５
＊１５
＊１６
０６
14-475
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
12 x 1.25 mm
28 N·m
(2.9 kgf·m,
21 lbf·ft)
8 x 1.25 mm
26 N·m (2.6 kgf·m, 20 lbf·ft)
B
C
A
A
Clearance: 2 mm (0.08 in.)
A
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
B
D
E
F
48. Install the ATF cooler lines (A) with the new sealing
washers (B) and the line bolts, then install the
harness clamp bracket (C).
49. Set the transmission range switch to the N position.
NOTE: The transmission range switch clicks in the
N position.
50. Set the control shaft (A) to the N position by turning
it.
NOTE: Be careful not to squeeze the end of the
control shaft tips together when turning into
position. If the tips are squeezed together it will
cause a faulty signal or position due to the play
between the control shaft and the switch.
51. Install the transmission range switch (A) gently on
the control shaft (B). Do not move the transmission
range switch when tightening its bolts.
52. Install the transmission range switch cover (C);
secure the harness with the bolt on the end cover
(D); install the harness clips (E) on the brackets (F).
(cont’d)
03/07/29 09:46:26 61S0X050_140_0478