Honda 2004 Odyssey, Service Manual

Page: 2450 / 2459

０１
０２
Ｓ０Ｘ４ＡＣ５Ｈ４６４０００５５４１１ＫＢＡＴ００
Removal (’02 Model) Installation (’02 Model)
23-385
Side Impact Sensor Replacement
B
C
A
C
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
B
NOTE:
• Removal of the side impact sensor must be
performed according to the precautions/procedures.
• Before disconnecting the side impact sensor 2P
connector(s), disconnect the side airbag 2P
connector(s).
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the side
impact sensor.
1. Disconnect the negative battery cable, and wait at
least 3 minutes before beginning work.
2. Remove the seat assembly (see page 20-81).
3. Remove the center pillar lower trim panel (see page
20-58).
4. Disconnect the side wire harness 2P connector (A)
from the side impact sensor (B).
5. Remove the Torx bolt (C) using a Torx T30 bit, then
remove the side impact sensor.
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the side
impact sensor.
1. Install the new side impact sensor with a new Torx
bolt (A) then connect the side wire harness 2P
connector (B) to the side impact sensor (C).
2. Reconnect the battery negative cable.
3. After installing the side impact sensor, confirm
proper system operation: Turn the ignition switch
ON (II): the SRS indicator should come on for about
6 seconds and then go off.
03/07/29 10:42:56 61S0X050_230_0385