Honda 2004 Odyssey, Service Manual

Page: 1683 / 2459

＊０５
０１
＊０６
＊０７
＊０８
＊０９
Handling Wires and Harnesses
22-4
Body Electrical
General Troubleshooting Information (cont’d)
A
B
A
DOWN
A
A
A B
• Check for loose retainer (A) and rubber seals (B).
• The backs of some connectors are packed with
dielectric grease. Add grease if necessary. If the
grease is contaminated, replace it.
• Insert the connector all the way and make sure it is
securely locked.
• Position wires so that the open end of the cover faces
down.
• Secure wires and wire harnesses to the frame with
their respective wire ties at the designated locations.
• Remove clips carefully; don’t damage their locks (A).
• Slip pliers (A) under the clip base and through the
hole at an angle, then squeeze the expansion tabs to
release the clip.
• After installing harness clips, make sure the harness
doesn’t interfere with any moving parts.
• Keep wire harnesses away from exhaust pipes and
other hot parts, from sharp edges of brackets and
holes, and from exposed screws and bolts.
• Seat grommets in their grooves properly (A). Do not
leave grommets distorted (B).
03/07/29 10:17:51 61S0X050_220_0006