Honda 2004 Odyssey, Service Manual

Page: 1266 / 2459

−
−
−
−
−
−
−
−
−
−
Ｓ０Ｘ４Ａ０７Ｋ７０１０００８１５１０ＦＡＡＴ００
０１
０６
Ｓ０Ｘ４Ａ０７Ｋ７０１０００８１５２０ＦＡＡＴ００
＋
DTC 51: DTC 52:
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
19-65 19-65
PUMP MOTOR RELAY CONNECTOR
B
(WHT)
MOTOR
(WHT/BLU)
JUMPER WIRE
PASSENGER’S UNDER-DASH
FUSE/RELAY BOX CONNECTOR J (16P)
MCK (GRN)
Motor Lock Motor Stuck OFF
1. Clear the DTC.
2. Test-drive the vehicle at 6 mph (10 km/h) or more.
Replace the modulator unit.
The system is OK at this time.
1. Check the ABS MOTOR (30A) fuse in the under-
hood fuse/relay box, and reinstall the fuse if it is OK.
Go to step 3.
Replace the fuse, and go to step 2.
2. Connect the pump motor relay connector terminal
No. 4 to No. 5 with a jumper wire for a moment,
and check the fuse.
Check for a short to body ground in the
motor power source circuit.
Go to step 3.
3. Remove the ABS MOTOR CHECK (7.5A) fuse in the
passenger’s under-dash fuse/relay box.
Remove the fuse, and go to step 4.
Replace the fuse, and recheck.
4. Turn the ignition switch ON (II).
5. Measure the voltage between the passenger’s
under-dash fuse/relay box connector J (16P)
terminal No. 5 and body ground.
Go to step 6.
Repair open in the wire between the
passenger’s under-dash fuse/relay box and the
ABS control unit.
(cont’d)
Terminal side of female terminals
Wire side of female terminals
Does the ABS indicator come on, and is DT C 51
indicated?
Is the f use OK ?
Is the f use blown?
Is the f use OK ?
Is ther e about 10 V ?
03/07/29 09:55:50 61S0X050_190_0065