Honda 2004 Odyssey, Service Manual

Page: 704 / 2459

−
−
−
−
−
−
−
０３
＊０２
０４
YES
NO
YES
NO
YES
NO
14-91
PCM CONNECTORS
B (25P)
LC (YEL)
LG1 (BRN/BLK) LG2 (BRN/BLK)
D (16P)
PCM CONNECTORS
B (25P)
LG1 (BRN/BLK)
LG2 (BRN/BLK)
D (16P)
VB SOL (BLK/YEL)
LOCK-UP CONTROL SOLENOID VALVE/
SHIFT CONTROL SOLENOID VALVE A
ASSEMBLY CONNECTOR (3P)
LC (BLU/YEL)
8. Disconnect the 3P connector from the lock-up
control solenoid valve/shift control solenoid valve
A assembly.
9. Check for continuity between the D1 and B20 or
B22 terminals.
Repair short to ground in the wire between
the D1 terminal and the lock-up control solenoid
valve.
Go to step 10.
10. Measure the resistance between the No. 3 terminal
of the lock-up control solenoid valve/shift control
solenoid valve A assembly connector and body
ground.
Check for an open in the wire between the D1
terminal and the lock-up control solenoid valve.
Replace the lock-up control solenoid valve/
shift control solenoid valve A assembly (see page
14-130).
11. Turn the ignition switch ON (II).
12. Measure the voltage between the D5 and B20 or
B22 terminals.
Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
Check for blown No. 6 (15A) fuse in the
driver’s under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between the D5 terminal
and the driver’s under-dash fuse/relay box.
Wire side of female terminals
Wire side of female terminals
Terminal side of male terminals
Is ther e continuity?
Is the r esistance 12 25 ?
Is ther e batter y voltage?
03/07/29 09:31:12 61S0X050_140_0094