Honda 2004 Odyssey, Service Manual

Page: 2307 / 2459

−
−
−
−
−
−
０１
＊０１
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ２２９ＸＦＡＡＴ００
’03-04 Models
DTC 22-9x (22-90 to 22-99, 22-9A to 22-9F):
Special Tools Required
YES
NO
YES
NO
YES
NO
23-242
SRS
DTC Troubleshooting (cont’d)
07TAZ-SZ5011A
07SAZ-TB4011A
A
A
07TAZ-SZ5011A
07SAZ-TB4011A
C581
Short to Ground in Front Passenger’s Seat
Belt Tensioner
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger’s seat belt
tensioner 2P connector from the right side wire
harness (A).
5. Connect the special tool (2 connector) to the
right side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Go to step 9.
Short to ground in the front passenger’s seat
belt tensioner; replace the front passenger’s seat
belt (see page 23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the SRS main harness 2P connector
C581 from the right side wire harness 2P
connector (A).
11. Connect the special tool (2 connector) to the SRS
main harness 4P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Go to step 15.
Short to ground in the right side wire harness;
replace the right side wire harness.
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Does the SRS indicator stay on?
Is DT C 22-9x indicated?
Is DT C 21-9x indicated?
03/07/29 10:38:09 61S0X050_230_0242