Honda 2004 Odyssey, Service Manual

Page: 2286 / 2459

−
−
−
−
−
−
０１
＊０１
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ２１１ＸＦＡＡＴ２０
’03-04 Models
DTC 21-1x (21-10 to 21-19, 21-1A to 21-1F):
Special Tools Required
YES
NO
YES
NO
YES
NO
23-221
07SAZ-TB4011A
07TAZ-SZ5011A
A
A
07TAZ-SZ5011A
07SAZ-TB4011A
C551
Open or Increased Resistance in Driver’s Seat
Belt Tensioner
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver’s seat belt tensioner 2P
connector from the left side wire harness (A).
5. Connect the special tool (2 connector) to the left
side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Go to step 9.
Open or increased resistance in the driver’s
seat belt tensioner; replace the driver’s seat belt
(see page 23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the SRS main harness 2P connector
C551 from the left side wire harness 2P connector
(A).
11. Connect the special tool (2 connector) to the SRS
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Go to step 15.
Open or increased resistance in the left side
wire harness; replace the left side wire harness.
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
(cont’d)
Does the SRS indicator stay on?
Is DT C 21-1x indicated?
Is DT C 21-1x indicated?
03/07/29 10:37:56 61S0X050_230_0221