Honda 2004 Odyssey, Service Manual

Page: 224 / 2459

０１
０４
1st step torque: 39 N·m (4.0 kgf·m, 29 lbf·ft)
2nd step torque: 69 N·m (7.0 kgf·m, 51 lbf·ft)
3rd step torque: 98.1 N·m (10.0 kgf·m, 72.3 lbf·ft)
Cylinder Head Bolts Torque Sequence
6-57
B
A
C
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
7. Apply new engine oil to the threads and flanges of
the cylinder head bolts.
8. Tighten the cylinder head bolts sequentially in
three steps.
NOTE: Perform each step twice.
Use a beam-type torque wrench. When using a
preset-type torque wrench, be sure to tighten
slowly and not to overtighten.
If a bolt makes any noise while you are torquing it,
loosen the bolt, and retighten it from the first step.
9. Install the timing belt (see page 6-23).
10. Adjust the valve clearance (see page 6-15).
11. Install the cylinder head cover (see page 6-34).
12. Install the exhaust manifold and tighten the nuts in
a crisscross pattern in two or three steps,
beginning with the inner nut (see page 9-10).
Always use a new exhaust manifold gasket.
13. Install the nuts securing the exhaust pipe A and
exhaust manifold, then install the cover on the
exhaust manifold.
14. Install the water passage (A). Always use a new O-
ring (B) and new gaskets (C).
(cont’d)
03/07/29 09:11:57 61S0X050_060_0057