Honda 2004 Odyssey, Service Manual

Page: 719 / 2459

−
−
−
−
−
−
−
０４
０６
＊０１
YES
NO
YES
NO
YES
NO
14-106
Automatic Transmission
DTC Troubleshooting (cont’d)
LG1 (BRN/BLK)
LG2 (BRN/BLK)
A (31P)
C (22P)
PCM CONNECTORS
SH C (GRN)
SHIFT SOLENOID VALVE C
CONNECTOR
LG1 (BRN/BLK)
LG2 (BRN/BLK)
A (31P) B (24P)
PCM CONNECTORS
VB SOL (BLK/YEL)
8. Disconnect the shift solenoid valve C connector
(2P).
9. Check for continuity between PCM connector
terminals C17 and A25 or A26
Repair short to ground in the wire between
PCM connector terminal C17 and the shift solenoid
valve C.
Go to step 10.
10. Measure the shift solenoid valve C resistance at the
solenoid valve connector.
Check for an open in the wires between PCM
connector terminal C17 and the shift solenoid valve
C, and between the No. 1 terminal of the shift
solenoid valve C connector and body ground
(G101).
Replace shift control solenoid valve C (see
page 14-131).
11. Disconnect PCM connector B (24P).
12. Turn the ignition switch ON (II).
13. Measure the voltage between PCM connector
terminals B24 and A25 or A26.
Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
Check for blown No. 6 (15A) fuse in the
driver’s under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between PCM connector
terminal B24 and the driver’s under-dash fuse/relay
box.
Wire side of female terminals
Terminal side of male terminals
Wire side of female terminals
Is ther e continuity?
Is ther e 12 25 ?
Is ther e batter y voltage?
03/07/29 09:32:23 61S0X050_140_0109